View Single Post
Unread 08-28-2013, 10:51 AM   #3
FrankTX
1st Gear Member
 
Join Date: May 2012
Posts: 6
Default

Quote:
Originally Posted by 3quarter32 View Post
I used Speedways mounts and had somewhat the same issue. I ended up leaving the mounts slightly loose on the block, then raised the engine up and down until the holes lined up. After the long mount bolt was installed, lowered the engine enough to tighten the engine mount bolts back up. Then let the engine set on its own weight. 2000 miles and no issues.
Lee

Thanks Lee good idea ! I will give that a shot .


Frank
FrankTX is offline   Reply With Quote